Now that you have installed AcuGraph, it is time to set up
your new software. This setup operation only needs to be
completed once. To set up your software and prepare it for
use, please follow these steps:
- Double-click on the AcuGraph 4 icon to start the
application.
- Read and accept the terms and conditions set forth in
the license agreement.
- REGISTRATION INFORMATION: A window
will appear requesting registration information.
NOTE: You MUST enter the information requested in the boxes marked with stars.
Please enter the information exactly as you want it to appear in your software registration.
When you have completed the registration screen, please press “Save.”
- A window will appear asking for your password. The
factory-set password is "energy" (all lower case,
without quote marks.) For information on changing
your password, click here.
- You will then be taken to the General Preferences
section. Please enter your practice information. This
information can be changed at any time by selecting
"Edit, Preferences." Click here for
information on other preferences you can change in this area.
- When you have entered your practice information,
press the “Save” button, followed by the “Close”
button.
- NOTE ABOUT PROBE TIPS: A standard cotton
swab (Q-tip brand or similar) with the tip cut off just
below the cotton is the best tip for your AcuGraph
probe. Insert the cotton tip into the AcuGraph probe
with a twisting motion to ensure the cotton makes
good contact with the metal of the probe. Also, for
proper patient hygiene, use a new tip with each
patient measured.
Congratulations!
Your AcuGraph system is ready for use!
